Author Topic: The dragon mother 85mm  (Read 567 times)

0 Members and 1 Guest are viewing this topic.

Nicholas Ball

  • Secretary
  • *****
  • Country: gb
Re: The dragon mother 85mm
« Reply #7 on: March 18, 2018, 01:31:40 PM »
Lovely engraved face :)

Tannenberg1410

  • Associate
  • **
  • Country: de
Re: The dragon mother 85mm
« Reply #6 on: March 18, 2018, 12:15:31 PM »
Hello everybody,

Today it was time now and I could do a trialcast of the dragon mother. The mold went very well and every casting was ok.
So now I hope that you like the figure.
Frank Dittmar
Asbacher Str. 18
98574 Schmalkalden

willie

  • Member
  • ***
Re: The dragon mother 85mm
« Reply #5 on: March 12, 2018, 05:52:21 PM »
Very nice figure :o Willie

Tannenberg1410

  • Associate
  • **
  • Country: de
Re: The dragon mother 85mm
« Reply #4 on: March 12, 2018, 04:25:19 PM »
Hello,

Engraving is one-sided.
Frank Dittmar
Asbacher Str. 18
98574 Schmalkalden

gerry Larkin

  • Member
  • ***
  • Country: gb
Re: The dragon mother 85mm
« Reply #3 on: March 12, 2018, 02:40:04 PM »
very nice indeed is the flat engraved both sides?

Brian

  • Member
  • ***
  • Country: gb
Re: The dragon mother 85mm
« Reply #2 on: March 12, 2018, 05:31:42 AM »
I'm going to have to get a few of your figures and defiantly one of these when ready!!  looking good! well done  ;)   
2D Figurines

Tannenberg1410

  • Associate
  • **
  • Country: de
The dragon mother 85mm
« Reply #1 on: March 11, 2018, 04:38:07 PM »
Hello everybody,

I started the next bust in my series. This is the current state. I hope you know who should be there. The dragon was pretty difficult and took a lot of time. But now the end is foreseeable.
Frank Dittmar
Asbacher Str. 18
98574 Schmalkalden

 

Powered by EzPortal