International Flat Figure Society - British Flat Figure Society

Flat Figures Painters Forum => News => Topic started by: Tannenberg1410 on March 11, 2018, 04:38:07 PM

Title: The dragon mother 85mm
Post by: Tannenberg1410 on March 11, 2018, 04:38:07 PM
Hello everybody,

I started the next bust in my series. This is the current state. I hope you know who should be there. The dragon was pretty difficult and took a lot of time. But now the end is foreseeable.
Title: Re: The dragon mother 85mm
Post by: Brian on March 12, 2018, 05:31:42 AM
I'm going to have to get a few of your figures and defiantly one of these when ready!!  looking good! well done  ;)   
Title: Re: The dragon mother 85mm
Post by: gerry Larkin on March 12, 2018, 02:40:04 PM
very nice indeed is the flat engraved both sides?
Title: Re: The dragon mother 85mm
Post by: Tannenberg1410 on March 12, 2018, 04:25:19 PM
Hello,

Engraving is one-sided.
Title: Re: The dragon mother 85mm
Post by: willie on March 12, 2018, 05:52:21 PM
Very nice figure :o Willie
Title: Re: The dragon mother 85mm
Post by: Tannenberg1410 on March 18, 2018, 12:15:31 PM
Hello everybody,

Today it was time now and I could do a trialcast of the dragon mother. The mold went very well and every casting was ok.
So now I hope that you like the figure.
Title: Re: The dragon mother 85mm
Post by: Nicholas Ball on March 18, 2018, 01:31:40 PM
Lovely engraved face :)