International Flat Figure Society - British Flat Figure Society
Flat Figures Painters Forum => Techniques => Topic started by: böckchen on April 26, 2013, 08:05:32 AM
-
Here I have to contribution on the topic soldering and rebuild of figures for you.
;D :o :o :o :o :o
1.
Transformer with DC 12-16 V
Fine Liner Pen with Kolephoniom (Graphit) mines
Who feasible a hard-write mine!
a red and a black wire
attach=1]
2.
gebochene figures, the vorberitete pin with the attached cable (black)
a clamp
[attach=2]
3.
attach the red cable to clamp to figure
[attach=3]
4.
Correct geometry of the parts on an underground brenbren not (here soldering ceramic plate)
[attach=4]
5-6.
The connecting of the two parts.
Caution!
It could be created by soldering gases warming the Koefhoniom mine
an insulated handpiece I would recommend (very rapid warming)
[attach=5]
7.
Figure with a stranger capita :) ;) ;) ;) ;) ;)
[attach=6]
This technique was very angewändet with success.
It stands at the Leipzig Feunden if anything is to be at the top umgebau references! 8) 8) 8)